Roland TD-25 - Optimizing the Pads; Changing the Type of Pad; Calibrating the Hi-Hat

Setup
11
Click
Here you can specify click settings.
Adjusting the Click
Parameter Explanation
Beat Time signature
Pattern Click interval
Sound Tone
Volume Volume
Pan Panning
Options
Here you can make overall settings for the entire TD-25.
Adjusting the Display
Parameter Explanation
LCD Contrast Adjusts the contrast of the display (Default: 12).
LCD Brightness Adjusts the brightness of the display (Default: 8).
Changing the Auto-O Setting
The TD-25 automatically powers-o when a certain length of time has elapsed since it was last operated
or played.
With the factory settings, this is set to “4 HOURS.”
* Thirty minutes before the power turns o, a message will appear in the display.
Parameter Explanation
Auto O
OFF The power will not turn o automatically.
4 HOURS The power will turn o automatically when four hours have elapsed.
Using USB Audio (USB Driver Mode)
This switches the USB driver mode that’s used when the TD-25 is connected to a computer via USB.
After changing this setting, you must power the TD-25 o and then on again.
Paramenter Value Operation Driver Explanation
USB Driver
GENERIC USB-MIDI Not required
Choose this if you want to transfer
MIDI messages between the TD-25
and your computer or iPad.
VENDOR
USB-AUDIO
USB-MIDI
Required
Choose this if you want to transfer
audio between the TD-25 and your
computer.
You can download the dedicated driver for the TD-25 from the Roland website.
http://www.roland.com/support/
For the operating requirements, refer to the Roland website. The driver program and installation
procedure will dier depending on your system. Please carefully read the “Readme.htm” included with
the les you downloaded.