Roland TD-25 Parameter Guide

18
TAPE ECHO
Simulates a tape-type echo unit of the past.
Parameter Value Explanation
Rate 0–127 Tape speed
Intensity 0–127 Amount of echo repeat
CHORUS
This is a stereo chorus. A lter is provided so that you can adjust the timbre of the chorus sound.
Parameter Value Explanation
PreDelay 0.0–100 msec
Adjusts the delay time from the direct sound until the chorus sound is
heard.
Rate 0–127 Frequency of modulation
Depth 0–127 Depth of modulation
Phase 0–180 deg Spatial spread of the sound
Filter Type OFF, LPF, HPF
Type of lter
OFF: no lter is used
LPF: cuts the high frequency range
HPF: cuts the low frequency range
Cuto 200–8000 Hz Frequency when using the lter to cut a specic frequency range
PHASER
A phase-shifted sound is added to the original sound and modulated.
Parameter Value Explanation
Mode
4-STAGE, 8-STAGE,
12-STAGE
Number of stages in the phaser
Manual 0–127 Adjusts the frequency from which the sound will be modulated.
Rate 0–127 Frequency of modulation
Depth 0–127 Depth of modulation
Resonance 0–127 Amount of feedback
STEP PHASER
This is a stereo phaser. The phaser eect will be varied gradually.
Parameter Value Explanation
Mode
4-STAGE, 8-STAGE,
12-STAGE
Number of stages in the phaser
Manual 0–127 Adjusts the frequency from which the sound will be modulated.
Rate 0–127 Frequency of modulation
Depth 0–127 Depth of modulation
Resonance 0–127 Amount of feedback
Step Rate 0–127 Rate of the step-wise change in the phaser eect
Eect Type Page
OFF
STEREO DELAY p. 18
REVERSE DELAY p. 18
TAPE ECHO p. 18
CHORUS p. 18
PHASER p. 18
STEP PHASER p. 18
FLANGER p. 19
REVERB p. 19
Eect Type Page
LONG REVERB p. 19
SATURATOR p. 19
SUPER FILTER p. 20
FILTER+DRIVE p. 20
AUTO WAH p. 20
LO-FI COMPRESS p. 20
DISTORTION p. 20
OVERDRIVE p. 21
ISOLATOR p. 21
Eect Type Page
RING MODULATOR p. 21
STEP RINGMOD p. 21
PITCH SHIFT p. 21
AUTO PAN p. 21
Parameter List
STEREO DELAY
This is a stereo delay.
Parameter Value Explanation
Time Left 0–1300 msec
Adjusts the delay time from when the direct sound begins until the left
delay sound is heard.
Time Right 0–1300 msec
Adjusts the delay time from when the direct sound begins until the
right delay sound is heard.
Feedback -98–+98 %
Proportion of the delay sound that is to be returned to the input.
Negative (-) settings invert the phase.
Phase Left NORMAL, INVERSE Phase of the left delay sound
Phase Right NORMAL, INVERSE Phase of the right delay sound
Wet Gain Low -15–+15 dB Amount of boost/cut for the eect sound’s lower range
Wet Gain High -15–+15 dB Amount of boost/cut for the eect sound’s upper range
REVERSE DELAY
This is a reverse delay that adds a reversed sound of the input sound as a delayed sound. A chorus is
connected immediately after the reverse delay.
Parameter Value Explanation
Threshold 0–127 Volume at which the reverse delay will begin to be applied
DlyTime 0–1300 msec
Delay time from when sound is input into the reverse delay until the
delay sound is heard
Feedback -98–+98 %
Proportion of the delay sound that is to be returned to the input of the
reverse delay.
Negative (-) settings invert the phase.
Multi Eects

Roland TD-25 Specifications

General

Metronome	Yes
Recorder	Yes
Outputs	Main Output (L/Mono, R)
MIDI	MIDI OUT
Type	Electronic Drum Module
Module	TD-25
Kick Pad	KD-9
Crash Cymbals	CY-12C
Ride Cymbal	CY-13R
Drum Kit Presets	25
Audio Inputs	1 (Stereo Mini)
Audio Outputs	Main Output (L/Mono, R)
Headphones	1
USB	USB MIDI
Trigger Inputs	9
Power Supply	AC adaptor (DC9V)
Inputs	Trigger Inputs, Audio Input