Multi Eects
20
AUTO WAH
Cyclically controls a lter to create cyclic change in timbre.
Parameter Value Explanation
Filter Type LPF, BPF
Type of lter
LPF: The wah eect will be applied over a wide frequency range.
BPF: The wah eect will be applied over a narrow frequency range.
Manual 0–127 Adjusts the center frequency at which the eect is applied.
Peak 0–127
Adjusts the way in which the wah eect applies to the area around the
center frequency.
Set a higher value for Peak to narrow the range to be aected.
Polarity UP, DOWN
Sets the direction in which the frequency will change when the auto-
wah lter is modulated.
UP: The lter will change toward a higher frequency.
DOWN: The lter will change toward a lower frequency
Rate 0–127 Frequency of modulation
Depth 0–127 Depth of modulation
LO-FI COMPRESS
This is an eect that intentionally degrades the sound quality for creative purposes.
Parameter Value Explanation
PreFilter Type1–3
Selects the type of lter applied to the sound before it passes through
the Lo-Fi eect.
Lo-Fi Type1–9
Degrades the sound quality. The sound quality grows poorer as this
value is increased.
Post Filter Type OFF, LPF, HPF
Type of lter after it passes through the Lo-Fi eect
OFF: no lter is used
LPF: cuts the frequency range above the Cuto
HPF: cuts the frequency range below the Cuto
Post Filter Cuto 200–8000 Hz Frequency of the Post Filter
Gain Low -15–+15 dB Gain of the low range
Gain High -15–+15 dB Gain of the high range
DISTORTION
Intensely distorts the sound. The tone quality of the distorted sound is adjusted with a lter.
Parameter Value Explanation
Pre HPF BYPASS, 16–1000 Hz
Frequency of the lter that cuts the low-frequency content of the input
sound (BYPASS: no cut)
Drive 0–127 Amount of distortion
Tone 0–127 Tone quality of distorted sound
SUPER FILTER
This is a lter with an extremely sharp slope. The cuto frequency can be varied cyclically.
Parameter Value Explanation
Filter Type LPF, BPF, HPF, NOTCH
Filter type
Frequency range that will pass through each lter
LPF: Frequencies below the cuto
BPF: Frequencies in the region of the cuto
HPF: Frequencies above the cuto
NOTCH: Frequencies other than the region of the cuto
Filter Cuto 0–127
Cuto frequency of the lter
Increasing this value will raise the cuto frequency.
Filter Resonance 0–127
Filter resonance level
Increasing this value will emphasize the region near the cuto
frequency
Modulation Switch OFF, ON On/o switch for cyclic change
Modulation Rate 0–127 Rate of modulation
Modulation Depth 0–127 Depth of modulation
FILTER+DRIVE
This is a low-pass lter equipped with overdrive. It cuts the upper range and adds distortion.
Parameter Value Explanation
Cuto 0–127
Cuto frequency of the lter
Increasing this value will raise the cuto frequency.
Resonance 0–127
Filter resonance level
Increasing this value will emphasize the region near the cuto
frequency
Drive 0–127 Amount of distortion
To Next Page
Loading...
Need help?
General
