Roland TD-25 - Appendices; List of Displayed Messages; Error Messages; Other Messages

22
Other Messages
Message Meaning Action
Cannot GROUP MUFFLING.
Select INSTRUMENT
with same parameter.
(MUFFLING or DECAY)
In order for you to turn on the [F2] (GROUP)
button and adjust the tom muing for
multiple toms, the muing parameter of all
toms 1–3 must be either MUFFLING or DECAY.
Change the instrument settings so that
the muing parameter of all toms 1–3 is
set to either MUFFLING or DECAY.
Clear current TOMS
INSTRUMENT assign, and
change to preset assign.
Press [OK] to Execute.
The instrument assigned to toms 1–3 is
cleared, and changes to the preset tom
settings.
If you want to change to the preset tom
settings, press [F3] (OK). If you decide to
cancel, press [F1] (CANCEL).
The modied settings will
become eective after
power o and restart.
The USB Driver settings take eect when you
turn the power of the TD-25 o and on again.
Turn the power of the TD-25 o and
on again.
List of Displayed Messages
Error Messages
Message Meaning Action
Data Damaged! The data on the USB ash drive is damaged. Do not use this le.
Empty Backup! No backup you request on the USB ash drive. —
MIDI Buer Full!
A large amount of MIDI messages were
received in a short time, and could not be
processed completely.
Conrm that the external MIDI device
is properly connected. If the problem
persists, reduce the amount of MIDI
messages sent to the TD-25.
No empty backup area
remains.
There are no empty backup area on the USB
ash drive.
Delete unneeded backup.
Song is too long!
The audio le cannot be played because it is
too long.
Play back an audio le that is no larger
than 2 GB.
Song is too short!
The audio le cannot be played because it is
too short.
Play back an audio le that is at least 1
second.
Audio les shorter than 1 second might
not play.
System Error!
A problem has occurred with the internal
system.
Contact your dealer or a nearby Roland
service center.
System Initialize Data in the TD-25’s memory may be corrupted.
Contact your dealer or a nearby Roland
service center.
USB drive is too busy. The data could not be read or written in time. Use a USB Flash Memory sold by Roland.
USB Memory Error!
The data on the USB ash drive is damaged. Do not use this le.
A USB ash drive the format of which is not
supported by TD-25 has been inserted.
Format the USB ash drive.
USB Memory Full!
There are no empty space on the USB ash
drive.
Delete unneeded data.
USB memory is not
connected!
No USB ash drive is in the USB MEMORY port.
Insert a USB ash drive correctly.
Use a USB Flash Memory sold by Roland.
No AUDIO REC Data! No recorded data exists. –
AUDIO REC Memory Full!
The capacity for audio recording is full, and
recording has stopped.
–
AUDIO REC Memory Error! An error occurred during recording. Insert a USB ash drive correctly.
Appendices