52
Chapter 5. Parameter guide
POLY SG (Polyphonic slow gear)
Simulates a volume-swell (violin-style) playing technique.
ON/OFF
Switch the slow gear on/off.
* By turning the VALUE dial you can select PRESET.
RISE TIME
0–100
Adjusts the time from when you pick the string until the
maximum volume is reached.
SENS
(Sensitivity) 0–100
Adjusts the sensitivity of the slow gear. With lower
sensitivity settings, the slow gear effect will not be applied to
softly picked notes, but only to strongly picked notes. With
higher sensitivity settings, the slow gear effect will be
applied regardless of your picking dynamics.
EQ (Equalizer)
A four band equalizer is provided, allowing you to adjust the
high and low ranges. You can adjust the emphasis of each
frequency band of the sound that has passed through the effect.
ON/OFF
Switches the equalizer on/off.
* You can turn the VALUE dial to select PRESET.
LEVEL
-20–+20dB
Adjusts the volume of the sound that has passed through the
equalizer.
HIGH G
(High gain) -20–+20dB
Adjust the tone of the upper range.
LOW G
(Low gain) -20–+20dB
Adjust the tone of the lower range.
L-MID G
(Low middle gain) -20–+20dB
Adjust the tone of the low midrange.
H-MID G
(High middle gain) -20–+20dB
Adjust the tone of the high midrange.
L-MID Q
(Low middle Q) 0.5–16
Adjust the width of the region surrounding the specified “L-
MID F” frequency that will be affected by the EQ. Higher
settings will make the region narrower.
L-MID F
(Low middle frequency) 20 Hz–10.0 kHz
Specify the center frequency at which the “L-MID G”
adjustment will occur.
H-MID Q
(High middle Q) 0.5–16
Adjust the width of the region surrounding the specified “H-
MID F” frequency that will be affected by the EQ. Higher
settings will make the region narrower.
H-MID F
(High middle frequency) 20 Hz–10.0 kHz
Specify the center frequency at which the “H-MID G”
adjustment will occur.
PAN
Specify the panning for the sound of each string.
* This cannot be switched on/off.
PRESET
Select one of the preset pan types.
STRING Hi–Lo
L=100, R=0–L=50, R=50–L=0, R=100
Specifies the left/right position for each string.
* If the sound is sent through the “WAH,” “EQ,” or “COMP/
LM” effect, the output will be monaural. If you want to
preserve the panning of the COSM BASS, use the Chain
function to connect the COSM BASS after the “WAH,”
“EQ,” and “COMP/LM” of the COSM AMP.
MIXER
Mixes the signals of the normal pickup and the divided
pickup.
* This cannot be switched on/off.
BALANCE
(Mixer balance)
CB=0, NP=100–CB=100, NP=0
Adjusts the volume balance of the COSM BASS and BASS IN.
LEVEL
0–100
Adjusts the volume of the COSM BASS.
STRING LEVEL Hi–Lo
0–100
Adjusts the volume for each string of the COSM BASS. This
is useful when you do not want a specific string to be output.
CB COSM bass
NP Normal pickup bass
To Next Page
Loading...
