Roland V-Bass - Gk Function; Dial Function

65
Chapter 5. Parameter guide
Chapter 5
EXP/GK VOL HOLD (EXP pedal/GK volume hold)
Specifies whether the positions of the EXP pedal and GK
VOL will be reflected when a patch is recalled.
EXP PEDAL CALIBRATION
(Expression pedal calibration)
Here you can adjust the operation of the EXP pedal.
1. Release the built-in EXP pedal, and press [F4].
The display will ask “ARE YOU SURE?”
2. To make the setting, press [WRITE].
* If you decide not to make the setting, press [EXIT] to return to
the Play screen.
3. Depress the built-in EXP pedal, and press [F6].
The display will ask “ARE YOU SURE?”
4. To make the setting, press [WRITE].
* If you decide not to make the setting, press [EXIT] to return to
the Play screen.
GK FUNCTION
Make settings to specify the function of the GK pickup.
DOWN/S1, UP/S2
Specify the function that will be assigned to the S1 switch
and S2 switch of the GK pickup.
* If this is set to anything other than “ASSIGNABLE,” the
PEDAL ASSIGN parameter GK S1/S2 settings and the
ASSIGN 1–8 source parameter GK S1/S2 settings will have
no effect.
GK VOL (GK volume)
Specifies the function that will be assigned to the SYNTH
VOL knob of the GK pickup.
* If this is set to anything other than “ASSIGNABLE,” the
PEDAL ASSIGN parameter GK VOL and the ASSIGN 1–8
source parameter GK VOL settings will be ignored.
DIAL FUNCTION
Specify how the VALUE dial will operate.
FUNCTION
Select the function of the VALUE dial.
ON The position of the various controllers will be reflect-
ed when a patch is selected.
OFF The patch will be selected in the state in which it was
written. (The position of the various controllers will
be ignored.)
ASSIGNABLE The switches will function as parameter
control buttons as specified by each
patch.
MASTER LEVEL Increase/decrease the master level.
PEDAL FUNC Hold down the S1/S2 switch of the GK-
2B and press one of the following V-Bass
pedals to assign the function.
Number pedal [1]:
MASTER LEVEL down
Number pedal [2]: MASTER LEVEL up
Number pedal [3]: TUNER
Number pedal [4]: TAP TEMPO
V-Bass CTL pedal: Control pedal
V-Bass EXP pedal: FOOT VOLUME
BANK pedal: FX-BYPASS
BANK pedal: MANUAL
PATCH SELECT Increment/decrement the patch num-
ber.
BYPASS/MANU The S1 switch will be assigned FX-BY-
PASS, and the S2 switch will be assigned
the MANUAL on/off function.
TUNER/TEMPO Assign the tuner function to the S1
switch, and the MASTER TEMPO (tap
input) function to the S2.
ASSIGNABLE The function will be specified by the pa-
rameter control knob setting within each
patch. Depending on the parameter that
is assigned, the GK pickup select switch
may not operate.
PICKUP LEVEL Controls the output level of the pickup
used in the COSM BASS block.
MIXER LEVEL Controls the MIXER LEVEL of the
COSM BASS.
MASTER LEVEL Controls the MASTER LEVEL.
P.NUMBER&VALUE In the Play screen, the dial will select
patches. In the Edit screens, it will
function as a value dial.
VALUE ONLY The dial will function only as a value
dial in the Edit screens.