Rosemount 3144 - SECTION 1 Introduction; Using this Manual; Getting Acquainted with the Transmitter; Software Compatibility

v
Table of Contents
SECTION 1
Introduction
UsingthisManual..................................1-1
Getting Acquainted with the Transmitter ................1-2
Software Compatibility..............................1-2
SECTION 2
Installation
Overview.........................................2-1
SafetyMessages...................................2-1
Warnings......................................2-1
Commissioning: On the Bench or in the Loop ............2-2
GeneralConsiderations..............................2-3
ElectricalConsiderations............................2-3
Power Supply...................................2-3
FieldWiring....................................2-4
Power/CurrentLoopConnections...................2-4
Grounding .....................................2-5
Surges/Transients................................2-6
Multichannel Installations .........................2-6
FailureModeandSecurityJumpers....................2-7
FailureModeJumper.............................2-7
TransmitterSecurityJumper.......................2-7
Changing the Position of the Failure Mode or
SecurityJumper.................................2-7
SensorConnections.................................2-8
RTD or Ohm Inputs ..............................2-8
Thermocouple or Millivolt Inputs ...................2-8
MechanicalConsiderations...........................2-9
Mounting......................................2-9
AccessRequirements.............................2-9
EnvironmentalConsiderations........................2-11
TemperatureEffects..............................2-11
MoistorCorrosiveEnvironments...................2-12
Hazardous Locations Installations ...................2-13
InstallationProcedure...............................2-13
TypicalNorthAmericanConfiguration...............2-13
TypicalEuropeanConfiguration....................2-15
Installation in Conjunction with a Model 333
HART Tri-Loop HART-to-Analog Signal Converter ......2-16
Commissioning the Transmitter for Use with the
HARTTri-Loop...................................2-17