5-7
Specifications and Reference Data
Ambient Temperature Effect
Transmitters may be installed in locations where the ambient
temperature is between –40 and 85 °C. Each transmitter is individually
characterized over this ambient temperature range at the factory in
order to maintain excellent accuracy performance in dynamic industrial
environments. The factory characterization technique is accomplished
through extreme hot and cold temperature profiling with individual
adjustment factors programmed into each transmitter. Transmitters
automatically adjust for component drift caused by changing
environmental conditions. Refer to Table 5-2 on page 5-11.
Physical Specifications Conduit Connections
½–14 NPT, PG13.5 (PG11), M20 3 1.5 (CM20), or JIS G ½ conduit.
HART communicator connections permanently fixed to power/signal
block.
Materials of Construction
Electronics Housing
Low-copper aluminum or CF-8M (cast version of 316 SST)
Paint
Polyurethane
Cover O-rings
Buna-N
Mounting
Transmitters may be attached directly to the sensor. Optional mounting
brackets B4 and B5 permit remote mounting. See Figure 6 on page 11.
Weight
Add 1.0 lb (0.5 kg) for meter or bracket options.
Enclosure Ratings
NEMA 4X, CSA Enclosure Type 4X, IP66, and IP68
Aluminum Stainless Steel
2.5 lb. (1.1 kg) 7.2 lb (3.3 kg)
To Next Page
Loading...
