37. Press and hold the ‘Tailgate raise’ switch until the
tailgate is fully raised and then release the switch.
0 No errors
0 No errors
0 No errors
Hyd Oil Temp
0 No errors
0 No errors
32
o
C
01.06.201309:00:00
Hyd_Oil_Pressure 210 Bar
2
• Tailgate should resume rotating upwards about
the hinge pins until fully raised when it should
stop without noticeable judder.
• ‘Vehicle reversing’ alarm should sound while
the ‘Tailgate raise’ switch is being pressed and
the tailgate is rising.
• When the tailgate is raised, the ‘Tailgate fully
raised’ pictogram should display on the control
panel screen.
• Immediately the tailgate reaches full height,
the compaction mechanism should complete
the number of full cycles shown by the white
number in the tip clear pictogram, i.e. packer
plate open, carriage plate down, packer
plate close and then carriage plate up, in one
continuous sequence until fully packed when it
should stop.
WARNINGS:
MAKE SURE THAT YOU KNOW THE HEIGHT
OF YOUR VEHICLE WITH THE TAILGATE
AND WASTE CONTAINER LIFTING DEVICE,
IF FITTED, RAISED.
DRIVER MUST BE IN CAB.
PARKING BRAKE MUST BE APPLIED.
ALL PERSONNEL MUST BE CLEAR OF
FRONT AND REAR OF VEHICLE.
VEHICLE MAY LURCH FORWARDS.
38. Firmly apply the footbrake. Then select a gear.
• ‘Tailgate out‑of‑locks’ warning buzzer in the
cab should sound immediately the gear is
selected.
39. Select Neutral ‘N’.
• ‘Tailgate out‑of‑locks’ warning buzzer in the
cab should silence immediately Neutral ‘N’ is
selected.
DAILY CHECKS
3‑9
OM1R-SM-GB01R
3
To Next Page
Loading...
