SCHEDULED MAINTENANCE
6‑17
OM1R-SM-GB01R
6.10.3 Waste container lifting device checks
1. Remove the side safety guards, to gain access to
components.
WARNING:
IF OPERATING LIFTING DEVICE
WITHOUT SAFETY GUARDS TO ACCESS
COMPONENTS FOR INSPECTION, STAND
CLEAR OF LIFTING DEVICE AND TAKE
EXTREME CARE TO AVOID MOVING PARTS.
2. Examine the condition of the following waste
container lifting device components for security,
displacement, wear, bearing wear, bush wear,
distortion, cracks, damage or corrosion, which
affect their strength or operation. Make sure that
brackets, fixings, welds and bolts are secure and
not creating a danger to other users:
• Carriage.
• Lifting side arms.
• Lifting stay arms.
• DIN arms.
• Lip clamp.
• Lip comb.
3. Refit the side safety guards.
6.10.4 Power Take-Off propeller
shaft (if fitted)
1. Examine the power take‑off propeller shaft
universal joints for security, worn bearings, damage
to grease seals and cracks.
2. Examine the power take‑off propeller shaft flange
nuts for security and condition.
3. Examine the power take‑off propeller shaft slider
joint and grease seal for wear and damage.
6.10.5 Hand wash unit (optional item)
1. Check the hand wash unit for, security of mounting,
damage, corrosion and leaks.
2. Check that it operates to specification.
6.10.6 Operational check
1. Unprop the tailgate (see Operator’s Handbook).
2. Carry out a full operational check of the body and
tailgate systems as described in Chapter 3 ‑ ‘Daily
checks’.
3. Check that all lamps and warning lamps emit light
of the correct colour, do not flicker and that their
illumination is not affected by the operation of any
other lamp or equipment.
4. Check that the audible warning devices, if fitted,
emit sounds correct to specification.
6
To Next Page
Loading...