SCHEDULED MAINTENANCE
6‑15
OM1R-SM-GB01R
6.9.6 Waste container lifting device checks
1. Remove the side safety guards, to gain access to
components.
WARNING:
IF OPERATING LIFTING DEVICE
WITHOUT SAFETY GUARDS TO ACCESS
COMPONENTS FOR INSPECTION, STAND
CLEAR OF LIFTING DEVICE AND TAKE
EXTREME CARE TO AVOID MOVING PARTS.
2. Examine the following hydraulic system
components and their mountings for, security,
fractures, displacement, wear, distortion, cracks,
damage, leaks or corrosion. Check that all split pins
and washers are present and undamaged.
• Waste container lifting device raise lower
cylinders (2 off).
3. Check all rigid hydraulic pipes for, security,
fractures, displacement, wear, distortion, cracks,
damage, leaks, corrosion, fouling by moving parts,
or chafing.
• Where pipes are held by clips or supported by
other means, ensure all clips and supporting
devices are present and securely attached and
fastened.
4. Check all flexible hydraulic hoses for, security,
fractures, displacement, wear, distortion, cracks,
damage, leaks, corrosion, deterioration, stretching
or twisting, fouling by moving parts, or chafing.
• Make sure hoses have sufficient room to move
as necessary without fouling any part of the
vehicle.
• Make sure there are no sharp bends.
• Check for signs of exposure to excessive heat.
• Check for leaks ‑particularly when the system
is in operation.
• Check for signs of weakness or bulging‑
particularly when under maximum pressure.
• Check for signs of perishing on the outer cover.
5. Examine all the electrical wiring looms, their
connectors, wires and mountings for, condition,
security, fractures, displacement, wear, distortion,
cracks, damage, or corrosion.
• Check that there is adequate insulation.
• Check that the position of cables will not
cause damage by chafing or heat such that the
insulation becomes ineffective.
6. Refit the side safety guards.
6
To Next Page
Loading...
