Operation
AC-F/G4x Family Installation and Programming Manual 21
4.3 Switching Operational Modes
The three modes of operation defined above, can be changed
through a few steps.
4.3.1 From Normal to Secure Mode
The default factory setting for the normal/secure code is 3838.
To change from Normal to Secure mode:
1. Enter the Normal/Secure code.
The Mode indicator flashes red.
2. Press # to confirm the Mode change.
The Mode indicator is red.
The auxiliary input of the controller can also be used to switch the
mode of operation from secure to normal and vice versa, if the
auxiliary input is selected it de-activates the Norma/Secure mode code
(see Section 5.8).
4.3.2 From Secure to Normal Mode
The default factory setting for the normal/secure code is 3838.
To change from Secure to Normal mode:
1. Enter the Normal/Secure code.
The Mode indicator flashes green.
2. Press # to confirm the Mode change.
The Mode indicator turns green.
The auxiliary input of the controller can also be used to switch the
mode of operation from secure to normal and vice versa, if the
To Next Page
Loading...
Need help?
General
