Programming
AC-F/G4x Family Installation and Programming Manual 31
The Mode indicator flashes red.
3. Enter the new Normal/Secure code.
The system returns to Normal mode.
You hear three beeps.
The Door indicator turns off.
The Mode indicator turns green.
5.6 Changing the Normal/Bypass Code
The Normal/Bypass code is also used to turn the door chime off and
on. Chime only functions with the BL-D40 External Sounder.
• The chime is only heard when the Lock Strike relay is activated by a
valid code entry.
• Wrong entries: You hear a long beep and the controller returns to
Normal mode.
• Code 0000 erases and deactivates the Normal/Bypass code.
To change the Normal/Bypass code:
1. Enter Programming mode.
2. Press 5 to enter Menu 5.
The Mode indicator flashes orange.
There are
four different ways to program the Normal/Bypass code
and door chime:
Disable both Bypass Code and the door
chime – enter the code 0000.
Disable Bypass Code and enable the
door chime – enter the code 0001.
To Next Page
Loading...
Need help?
General
