Programming
AC-F/G4x Family Installation and Programming Manual 25
5. Programming
• In the Programming chapter, “code” refers to a PIN code or
proximity card depending on the unit you have.
• When entering a PIN or presenting a proximity card is mentioned,
the meaning may vary between units.
5.1 Introduction
Programming an access control unit is done solely via the unit’s
keypad-driven Programming Menu System. To reach the
Programming Menu System, the controller must first be placed into
Programming Mode (see Section 5.1.1
).
During the manufacturing process, certain codes and settings are pre-
programmed. These settings are the called default factory settings.
To Next Page
Loading...
