Programming
30 AC-F/G4x Family Installation and Programming Manual
5.4 Changing the Programming Code
• The code 0000 is not valid; thus, the programming code cannot be
erased.
• For wrong entries, you hear a long beep and the controller returns
to Normal mode.
To change the Programming code:
1. Enter Programming mode.
2. Press 3 to enter Menu 3.
3. Enter a new Programming code.
The Mode indicator turns green.
4. The system returns to Normal mode.
You hear three beeps.
The Door indicator turns off.
The Mode indicator turns green.
5.5 Changing the Normal/Secure Code
• When the auxiliary mode is 1, 2, 3 or 4, the auxiliary input takes
priority over the Normal/Secure code.
• For wrong entries, you hear a long beep and the controller returns
to Normal mode.
•
Code 0000 erases and deactivates the normal/secure code.
To change the Normal/Secure code:
1. Enter Programming mode.
2. Press 4 to enter Menu 4.
To Next Page
Loading...
