Programming
40 AC-F/G4x Family Installation and Programming Manual
5.9 Setting the Lockout Feature
If the controller is presented with wrong codes, (PIN or Card)
consecutively several times the unit goes into lockout mode.
When a lockout occurs, the controller keypad and reader are locked
so no codes can be entered until the set lockout period expires.
During Lockout, Mode LED is Off, Door LED flashes Red, and the
controller beeps every two seconds
.
The default setting for the Lockout Feature is 4000 (Lockout
Disabled).
Using the lockout feature is highly recommended, especially
when selecting to use short PIN code length (4 or 5 digits).
To define the Lockout feature:
1. Enter Programming mode.
2. Press 6 to enter Menu 6.
The Mode indicator flashes green.
3. Construct a code using the following instructions:
Set the number of wrong code attempts,
which causes a Lockout between 0 and 9
attempts.
Sets the duration of the lockout, between
00 and 99; the value is multiplied by ten,
resulting in 0 to 990 seconds.
To Next Page
Loading...
