Rotax 915 i A SERIES - Standard Engine Operation Procedures

3) Standard operation
Topics in this chapter
3.1 Daily checks .........................................................................................2
3.2 Pre-flight checks ...................................................................................5
3.3 Engine start .......................................................................................... 6
3.4 After engine start ................................................................................. 10
3.5 Engine run-up ..................................................................................... 11
3.6 Engine shut-off.................................................................................... 19
Introduction
To warrant reliability and efficiency of the engine, meet and
carefully observe all the operating and maintenance
instructions.
The following description of procedures depends on the
respective type of installation in the aircraft and shall therefore
only be seen functionally.
NOTE
The control elements mentioned in this chapter are only
symbolic and should support the understanding of the
procedures. The execution of control elements is in the
responsibility of the aircraft manufacturer.
Effectivity: 915 i A Series
Edition 0 / Rev. 0
BRP-Rotax Page 3-1
December 01 2017