Rotax 915 i A SERIES User Manual

Effectivity: 915 i A Series
Edition 0 / Rev. 0
BRP-Rotax Page 3-17
December 01 2017
Step Step Description Procedure
Pilot Display: Check
11 Activate ECU Lane B HIC B: Connect Terminal 1 and
Terminal 9 to power ECU Lane
B.
Example (Symbolic) Lane select Switch B: ON
12 Await Warning Indi-
cator B to extinguish
and consider slack
time.
HIC A: 12 V voltage drop be-
tween Terminal 2 and Terminal
10 for 3 seconds.
NOTE
After the voltage drop between Terminal 2 and ter-
minal 10 changes back to 0 V wait approx 3 sec-
onds until continuing with the next step.
Example (Symbolic) Warning Lamp B: Check
13 Reduce Throttle
Valve as required
Set linearized throttle position
to reach an engine speed of
2000 rpm and continue with
Fuel pump check
Example (Symbolic) Set Throttle
Fuel pump check
It must be ensured, that both fuel pumps are working and no
loss of power or irregular running by deactivation of one fuel
pump occurs. The limits for fuel pressure must not be
exceeded.
Step Step Description Procedure
1 Check engine instru-
ments (Warning Indi-
cators and
Operational Limits)
and ensure compli-
ance with the operat-
ing limits while step 2
– 8.
HIC A: If a 12 V voltage drop
between Terminal 2 and Termi-
nal 8 (permanent or oscillating)
is detected, shut OFF engine
and perform troubleshooting.
HIC B: If a 12 V voltage drop
between Terminal 2 and Termi-
nal 10 (permanent or oscillat-
ing) is detected, shut OFF
engine and perform
troubleshooting.
Display CAN A/B: Check and
ensure compliance with opera-
tional limits.
Example (Symbolic) Warning Lamp A: Check
Warning Lamp B: Check
Pilot Display: Check

Rotax 915 i A SERIES Specifications

General

Brand	Rotax
Model	915 i A SERIES
Category	Engine
Language	English