EasyManuals Logo

Rotax OM-912 Maintenance Manual

Rotax OM-912
456 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
00-00-00
Effectivity 912/914 Series
Edition 1 / Rev. 0
page 27
May 01/2007
d02620
BRP-Rotax
Maintenance Manual
9) Classification of parts for maintenance/repair
See Figs. 00-3 and 00-4.
As for an overhaul, parts for maintenance/repair must be classified. They are classified
either as “parts usable” or as “parts to be replaced”.
The classification is made on the basis of the following criteria:
Hours of operation (decisive are the total operating hours of the part / engine or
hours since the last overhaul)
Determined (measured) actual dimension of the respective parts.
See Figs. 00-3 and 00-4 for the classification of such parts.
Proceed as follows:
Determine wear as a percentage of the wear tolerance
(see the dimension sheets attached directly after each section for the wear limit
(100%) of the part in question).
Determine the hours of operation for the part in question (see Log book etc.)

Table of Contents

Other manuals for Rotax OM-912

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rotax OM-912 and is the answer not in the manual?

Rotax OM-912 Specifications

General IconGeneral
BrandRotax
ModelOM-912
CategoryEngine
LanguageEnglish

Related product manuals