Rotex HPSU compact 304 Installation And Maintenance Manual

6
FA ROTEX HPSU compact 4 - 06/2015
2 x Safety
2.2.4 Handling instructions
Ɣ Instructions on actions are shown as a list. Actions of which
the sequential order must be maintained are numbered.
Î
Results of actions are identified with an arrow.
Entry into a setting procedure
Exit from a setting procedure
2.3 Avoid danger
The ROTEX HPSU compact is state-of-the-art and is built to meet
all recognised technical requirements. However, improper use
can lead to serious injuries or death, as well as causing material
damage.
To prevent such risks, install and operate ROTEX HPSU
compact only:
– as stipulated and in perfect condition,
– with an awareness of the safety and hazards involved.
This assumes knowledge and use of th
e contents of this manual,
the relevant accident prevention regulations and the recognised
safety-related and occupational medical rules.
WARNING!
This unit is not intended for use by persons (including
chi
ldren) with impaired physical, sensory or mental
faculties or persons with insufficient experience and/or
expertise unless supervised by a person responsible
for ensuring their safety or are given instruction by this
person on how to use the unit.
2.4 Intended use
The ROTEX HPSU compact may only be used for preparation of
warm water, as a room heating system, and depending on its
design, as a room cooling system.
The ROTEX HPSU compact must be installed, connected and
operated only according to the indications in this manual.
Only use of a suitable external unit approved by ROTEX is per-
mitted. The following combinations are permissible in this re-
spect:
Internal unit External unit
HPSU compact 304
(H/C) DB
14 15 30
RRLQ004CAV3 14 51 51
HPSU compact 304
(H) DB
14 15 39
HPSU compact 304
(H/C) BIV
14 15 34
HPSU compact 304
(H) BIV
14 15 42
HPSU compact 308
(H/C) DB
14 15 31
RRLQ006CAV3
RRLQ008CAV3
14 51 52
14 51 53
HPSU compact 308
(H) DB
14 15 40
HPSU compact 308
(H/C) BIV
14 15 35
HPSU compact 308
(H) BIV
14 15 42
HPSU compact 508
(H/C) DB
14 15 32
RRLQ006CAV3
RRLQ008CAV3
14 51 52
14 51 53
HPSU compact 508
(H)
DB
14 15 41
HPSU compact 508
(H/C) BIV
14 15 36
HPSU compact 508
(H) BIV
14 15 44
HPSU compact 516
(H/C) DB
14 15 33
RRLQ011CAW1
RRLQ014CAW1
RRLQ016CAW1
14 51 48
14 51 49
14 51 50
HPSU compact 516
(H)
DB
14 15 38
HPSU compact 516
(H/C) BIV
14 15 37
HPSU compact 516
(H) BIV
14 15 45
BIV - Additional heat exchanger for the bivalent connection
Tab. 2-1 Permissible combinations of ROTEX HPSU compact internal
units and ROTEX heat pump external units
Any other use outside the intended use is considered as im-
proper. The operator alone shall bear responsibility for any re-
sulting damage.
Use as intended also involves compliance with maintenance and
inspe
ction conditions. Spare parts must at least satisfy the tech-
nical requirements defined by the manufacturer. This is the case,
for example, with original spare parts.
Internal unit External unit

Rotex HPSU compact 304 Specifications

General

Brand	Rotex
Model	HPSU compact 304
Category	Controller
Language	English