3.12
[en] 02/2014
Installation and operating manual - NK 31ROTORCOMP VERDICHTER
3.11.2 Fine separator cartridge
Figure 3-11
1. De-oiled compressed air
2. Post-separator
3. Fine separator
4. Pressure-resistant support pipe
5. Separated oil
6. Outlet of de-oiled air
7. Inlet of air-oil mixture
8. Sealing off
9. Pressure-resistant housing
The ne separator cartridge is used to recover
the extremely nely distributed residual oil in the
form of droplets following the pre-separation.
The ne separator cartridge separates virtually
the entire residual oil from the compressed air.
An optimum pre-separation in the separating tank
is assumed - the better the pre-separation, the
better the ne separation.
The vertical cartridge is owed against from be-
low, while the residual oil is separated out while
owing through the special lter element. Then it
is fed into the oil circulation again.