To Next PageTo Next Page
Need help?Do you have a question about the Rotronic HygroFlex and is the answer not in the manual?
General| Brand | Rotronic |
|---|---|
| Model | HygroFlex |
| Category | Transmitter |
| Language | English |
Explains the available power modules and voltage options for the HygroFlex.
Details the types of probes and input configurations supported by HygroFlex models.
Covers the RS-232 and RS-485 serial interfaces and their settings.
Describes using the internal service connector for instrument configuration with HW4 software.
Guides on setting up and addressing devices in an RS-485 multi-drop network.
Explains how to select the probe supply voltage using PCB jumpers.
Identifies and describes the function of each connector on the main PCB.
Provides detailed pin-out diagrams for all connector types on the plate.
Shows wiring diagrams for voltage and current analog outputs.
Provides guidelines for properly grounding the HygroFlex unit.
Instructions for configuring transmitters for RS-485 network use.
Function to select calculated humidity parameters like dew point, enthalpy, etc.
Allows calibration of digital probes at multiple temperature and humidity points.
Performs a single-point offset adjustment for digital probes.
Calibrates probe 1 using probe 2 as a reference.
Allows adjustment functions via HygroPalm 3.
Discusses requirements for accurate temperature calibration.
Explains humidity calibration using standards and devices.
