Introduction / Safety / Installation
1-3 HP6A Manual
7. USE THE RECOMMENDED ACCESSORIES. Consult the manual for recommended
accessories. The use of improper accessories may cause risk of injury.
8. CHECK DAMAGED PARTS. Before further use of the machine, a guard or other part that is
damaged should be checked to determine that it will operate properly and perform its intended
function. Check for alignment of moving parts, breakage of parts, mounting, and other conditions
that may affect its operation. A guard or other part that is damaged should be properly repaired
or replaced.
9. NEVER OPERATE A MACHINE WHEN TIRED, OR UNDER THE INFLUENCE OF DRUGS OR
ALCOHOL. Full mental alertness is required at all times when running a machine.
10. NEVER ALLOW UNSUPERVISED OR UNTRAINED PERSONNEL TO OPERATE THE
MACHINE. Make sure any instructions you give in regards to machine operation are approved,
correct, safe, and clearly understood.
11. IF AT ANY TIME YOU ARE EXPERIENCING DIFFICULTIES performing the intended operation,
stop using the machine! Then contact our service department or ask a qualified expert how the
operation should be performed.
No list of safety guidelines can be complete. Every shop environment is
different. Always consider safety first, as it applies to your individual working conditions. Use
this and other machinery with caution and respect. Failure to follow guidelines could result in
serious personal injury, damage to equipment or poor work results.
Electrical Power:
All electrical power should be removed from the machine before opening
the rear electrical enclosure. It is recommended that the machine have a electrical LOCK-OUT
device installed.
Make sure all electrical equipment has the proper electrical overload protection.
In the event of an electrical short, grounding reduces the risk of electric shock by providing a path of least
resistance to disperse electric current.
Electrocution or a fire can result if the machine is not grounded correctly.
Make sure the ground is connected in accordance with this manual. DO NOT operate the machine
if it is not grounded.
No single list of electrical guidelines can be comprehensive for all shop
environments. Operating this machinery may require additional electrical upgrades specific to
your shop environment. It is your responsibility to make sure your electrical system comply with
all local codes and ordinances.
Machine Operator:
Operator of this HP6A Honing machine should be a skilled machinist craftsman:
that is well versed in the caution, care, and knowledge required to safely operating a metal cutting tool.
To Next Page
Loading...