Material Data Safety Sheets 8-2 HP6A Manual
MOBILMET UPSILON 665554 Page 2 of 4
********************************** VI.
FIRE AND EXPLOSION HAZARD DATA
********************
Flash point F(C): > 325 ( 163) (ASTM D-92)
Flammable limits. LEL: .6 UEL: 7.0
Extinguishing media: Carbon dioxide, foam, dry chemical and water fog. Special fire fighting procedures:
Firefighters must use self-contained breathing apparatus.
Unusual fire and explosion hazards: None
NFPA hazard ID: Health: 0, Flammability: 1, Reactivity: 0
******************************************* VII.
REACTIVITY DATA
*****************************
Stability (thermal, light, etc.): Stable
Conditions to avoid: extreme heat
Incompatibility (materials to avoid): Strong oxidizers
Hazardous decomposition products: Carbon monoxide.
Hazardous polymerization: Will not occur
************************************** VIII.
SPILL OR LEAK PROCEDURE
***********************
Environmental impact: Report spills as required to appropriate authorities. U.S. Coast Guard regulations
require immediate reporting of spills that could reach any waterway including intermittent dry creeks.
Report spill to Coast Guard toll free number 800-424-8802.
Procedures if material is released or spilled: Adsorb on fire retardant treated sawdust, diatomaceous
earth, etc. Shovel up and dispose of at an appropriate waste disposal facility in accordance with
current applicable laws and regulations, and product characteristics at time of disposal.
Waste management: Product is suitable for burning in an enclosed, controlled burner for fuel value or
disposal by supervised incineration. Such burning may be limited pursuant to the Resource Conservation
and Recovery Act. In addition, the product is suitable for processing by an approved recycling facility or
can be disposed of at any government approved waste disposal facility. Use of these methods is subject
to user compliance with applicable laws and regulations and consideration of product characteristics at
time of disposal.
************************ IX. SPECIAL PROTECTION INFORMATION *************
Eye protection: No special equipment required.
Skin protection: If prolonged or repeated skin contact is likely, oil impervious gloves should be worn.
Good personal hygiene practices should always be followed.
Respiratory protection: No special requirements under ordinary conditions of use and with adequate
ventilation.
Ventilation: No special requirements under ordinary conditions of use and with adequate ventilation.
****************************************** X.
SPECIAL PRECAUTIONS
***************************
Storage: See Appendix for precautionary label. CL-402
To Next Page
Loading...