Power on the System
VX-601 will be auto power off after one minute when the power supply is removed. If you
use software to power off the system, please remember to remove the power supply too;
otherwise, the device will auto reboot again.
VX-601 has two power modes for user preference which can be activated through DashON. If
you want to use power source via power adapter, please disable “ACC Input Detection”.
To turn on the system, please follow the directions below:
1. Press power button to turn on the system
2. When VX-601 is in “Non-ACC mode” (*Default is Non-ACC mode), the device will not auto
power off when the power supply is removed (charged from UPS battery instead), please
use windows commend to fully shut down the device.
3. When VX-601 is in “ACC Sense Mode”, please follow the directions below:
When the system is off, switch the ignition from off to on, the system will turned
on/delay on.
When the system is off and the ignition is off, press the power button, the system will
be turned on/no delay on.
When System is off and the ignition is on, press the power button, the system will be
turned on/no delay on.
To Next Page
