Need help?Do you have a question about the RuggON VX-601 and is the answer not in the manual?
General| Operating System | Windows 10 IoT Enterprise |
|---|---|
| Storage | 256 GB SSD |
| Bluetooth | Bluetooth 4.2 |
| RAM | 8 GB |
| Wireless | Wi-Fi 802.11ac |
| Camera | 8 MP rear, 2 MP front |
| I/O Ports | USB 3.0, HDMI, Micro SD card slot |
| Ruggedness | MIL-STD-810G, IP65 |
| Connectivity | 4G LTE |
| Sensors | Accelerometer, Ambient Light Sensor |
Details on CE marking and environmental specifications.
Information regarding R&TTE Directive compliance.
Safety guidelines for the lithium battery.
Detailed specifications of the device's hardware components.
Information on supported operating systems.
Environmental operating conditions and specifications.
Description of the device's input/output ports.
Physical dimensions and weight of the device.
Physical dimensions and weight of the standard VX-601.
Physical dimensions and weight of the VX-601 with water-proof box.
Contents included in the product package.
Instructions for installing and removing the M.2 module.
Step-by-step guide for M.2 module installation/removal.
Process for installing and removing SIM cards.
Details on the internal SIM card slot.
How to install or remove the WWAN module.
Steps for connecting WWAN antennas.
Connecting external antennas for WWAN.
General instructions on powering the system.
Details on using the power connector.
Connecting power from a car power cable.
Connecting power from an external adapter.
Step-by-step guide to turn on the system.
Diagram showing connectors on the bottom of the device.
Pin configuration for the power connector.
Pin assignments for the COM1 serial port.
How to view system hardware and software information.
Displaying vehicle information via the simulator.
Enabling/disabling wireless communication modules.
Steps to enable or disable Wi-Fi and Bluetooth.
Configuring WWAN module settings.
Overview of system status and configuration options.
Setting up power management configurations.
Configuration for ACC sense mode.
Setting the input voltage range for the device.
Configuring delays for system power on/off.
Setting the system shutdown delay after ACC off.
Configuring device wake-up events.
Setting up scheduled wake-ups using RTC.
Enabling system wake-up via SMS.
Configuring input/output settings.
Settings for the COM1 serial port.
Settings for the COM2 serial port.
Adjusting the display brightness.
Configuring and testing the watchdog timer.
Customizing programmable buttons.
Configuring GPS and G-Sensor settings.
Enabling or disabling the GPS receiver.
Selecting the COM port for GPS connection.
Setting the baud rate for the GPS receiver.
Defining the boot order of devices.
Basic system configuration settings.
How to view or set the system date.
How to view or set the system time.
Displaying system configuration details.
Configuring boot options like CSM support.
Configuring system I/O device functions.
Setting passwords to protect BIOS or system startup.
Establishing password protection for the hard disk drive.
Creating a temporary wireless network for device sharing.
Saving network configurations for future use.
To Next Page
