RUKO F11PRO 2 - Remote Controller Pairing

F11PRO 2 User Manual
4.4 Remote Controller Pairing
+ Before each flight, you need to pair the aircraft with the remote
controller. Pairing takes about 20 seconds, and you can only
operate the aircraft once pairing is successful. Follow these steps
to pair:
()Turn on the aircraft.
(2)Turn on the remote controller.
(3)The aircraft and remote controller will pair automatically. During
pairing, the remote controller will emit a 'beep-beep' sound. Pairing
is complete when the sound stops.
+ Once pairing is successful, the aircraft's LED light will change
from blinking yellow to a solid red (indicating no GPS signal) or to
a solid green (indicating GPS signal acquired).
A
- Before each flight, check the battery level of the remote
controller. The remote controller will emit a warning sound when
the battery is low.
- If the remote controller is idle for 10 minutes, it will automatically
power off. To resume normal operation, move the joystick or press|
any button.
When using the remote controller with a mounted device, make
sure the device is securely clamped to prevent it from slipping.
Store the remote controller with a battery level of around
3.8-3.9V. Charge the battery approximately every month to
maintain its health.
Copyright ©2024 Ruko All Rights Reserved. 29