RUKO F11PRO 2 - Signal Loss

F11PRO 2 User Manual
6.9.4 Lost Signal RTH
« If the remote controller's battery is low, turned off, or lost signal for
10 seconds, the aircraft will enter automatic return-to-home mode
and return to the Home Point.
If the remote controller reconnects during the RTH process and you
wish to cancel the return, you can press the RTH button to cancel it.
Lost Signal RTH process:
(1) Record Home Point. (For information about the Home Point, refer
to section 3.4.1)
(2) Trigger RTH ( triggered by low battery of remote controller,
signal loss, etc.).
(3) After triggering the RTH, the aircraft adjusts the nose direction
and starts to return home,
(4) The aircraft automatically flies to the Home Point, then starts to
land, and completes the return.
Signal Loss
- When out of control, the aircraft cannot avoid obstacles.
- When the GPS signal is weak, the aircraft cannot return to home
automatically.
Copyri 4 Ruko Al Rights Reserved. 51