RUKO F11PRO 2 - Pre-Flight Checklist; Pairing Remote Controller with Aircraft

F11PRO 2 User Manual
6.2 Pre-Flight Checklist
« Ensure that the remote controller, smart flight battery, and mobile
device have sufficient power.
Make sure the aircraft's arms are fully extended.
Ensure the battery compartment cover is securely fastened and the
smart flight battery is properly installed.
Check that the propellers are not damaged, worn, or deformed, and
that there are no foreign objects tangled in them. Ensure they are
securely installed.
Make sure GPS is enabled to avoid losing signal, and fly outdoors in
an open area.
Check that the data cable connecting the remote controller and
mobile device is securely installed.
After powering on, verify that all four motors start normally and
that their speeds are consistent.
Ensure the camera is clean.
If replacing parts, always use original manufacturer components.
Using non-original parts can pose a risk to the safe operation of the
aircraft. For details on supported accessories, refer to the
accessories support page in the appendix of the user manual.
6.3 Pairing Remote Controller with Aircraft
* Please refer to section 4.4.4.
Copyright ©2024 Ruko All Rights Reserved. 39