RUKO F11PRO 2 - Basic Flight; How to Take off the Aircraft; Aerial Photography Tips

F11PRO 2 User Manual
6.11 Basic Flight
6.11.1 Basic Flight Steps:
(1) Place the aircraft on a flat, open surface with the front of the
aircraft facing forward and the rear facing the pilot.
(2)Press and hold the power button to turn on the aircraft.
(3)Short press then long press the power button on the remote
controller to turn it on. The aircraft and remote controller will
automatically pair, which takes about 20 seconds.
(4)Once pairing is complete, connect the phone to the remote
controller using a data cable.
(5)Open the Ruko Mini app and enter the operating interface.
(6)Wait for the GPS signal search to complete; the aircraft's indicator
light will be solid green.
(7)Unlock and start the motors.
(®)Slowly push the throttle stick up to achieve a smooth takeoff.
(9)Pull down the throttle stick to descend.
(10) After landing, pull the throttle stick to its lowest position and hold
it there until the motors stop.
(11) After stopping the motors, turn off the power of the aircraft and
the remote controller in sequence.
6.12 Aerial Photography Tips
(1) Perform the pre-flight check.
(@lt's recommended to take photos or record videos in Stable Mode.
(3)Choose clear, calm weather for shooting.
(4)During flight, make small, smooth stick movements to keep the
aircraft stable.
Copyright ©2024 Ruko All Rights Reserved. 59