Signal Breakout Module
Revision C, August 2013
16-6
To decode the digital waveform data do the following:
Read in byte by byte
If byte has bit 7 clear, save as low byte
If byte has bit 7 set and there was a previous stored low byte
Then the 2-byte packet is complete and can be decoded.
StaleFlag + HighByte and 64, Stale flag is bit 6 of high byte
BitOut = HighByte and 32, Bit output is bit 5 of high byte
IntVal=((HighByte and 31)*128)+LowByte digital count decoded
To Next Page
Loading...