English
10
52
• Remove the screws.
• Remove the gearwheel.
D screws
E gearwheel
• Unscrew and remove the adjustment ring nut and clean both grinders
with a vacuum cleaner and a brush.
Check the grinders wear. In case of clear
damages, replace them.
F adjustment ring nut
Follow the instructions below, to re-assemble the coffee grinder:
• Screw the adjustment ring nut until the limit stop, then loosen it by
1/2 turn.
This 1/2 turn loosening of the ring nut is
necessary to avoid grinders block and
damage.
• Put the gearwheel back in its position and fix it by tightening the screws.
• Put the coffee bean hopper back in its position.
Make sure to place the gasket properly. It
has to correctly engage with the gearwheel
and the ring nut.
• Fix the container by tightening the screws with the appropriate tool.
Mod. LUXE / Mod. COFFEE / Mod. CAPPUCCINO / Mod. CAPPUCCINO
USA / Mod. POWER STEAM / Mod. SELF
Mod. DUO
• Open the partition.
Before re-starting the machine, it is
necessary to adjust the grinding again.
Mod. LUXE / Mod. COFFEE / Mod. CAPPUCCINO / Mod. CAPPUCCINO
USA / Mod. POWER STEAM / Mod. SELF
Mod. DUO
A partition
To Next Page
Loading...
