SAJ H2 Series Instruction Manual

1.2.2 Explanations of Symbols 1.2.3 Safety Instructions
Symbol
Description
This device is directly connected to public grid, thus all work to the inveer shall only be
carried out by qualied personnel.
Danger to life due to high electrical voltage!
There might be residual currents in inveer because of large capacitors. Wait 5 MINUTES
before you remove the front lid.
Notice, danger!
This is directly connected with electricity generators and public grid.
Danger of hot suace
The components inside the inveer will release a lot of heat during operation. Do not
touch metal plate housing during operating.
An error has occurred
Please go to Chapter 9 “Troubleshooting” to remedy the error.
This device SHALL NOT be disposed of in residential waste
Please go to Chapter 8 “Recycling and Disposal” for proper treatments.
CE Mark
With CE mark & the inveer fullls the basic requirements of the Guideline Governing
Low-Voltage and Electro-magnetic Compatibility.
RCM Mark
Equipment meets safety and other requirements as required by electrical safety
laws/regulations in Australian and New Zealand.
No unauthorized peorations or modications
Any unauthorized peorations or modications are strictly forbidden, if any defect or
HYBRID SOLAR INVERTER INSTRUCTION MANUAL
damage (device/person) occurred, SAJ shall not take any responsibility for it.
· Do not touch the operating component of the inveer; it might result in burning or death.
·To prevent risk of electric shock during installation and maintenance, please make sure that all AC and DC terminals
are plugged out.
· Do not touch the suace of the inveer while the housing is wet, otherwise, it might cause electrical shock.
· Do not stay close to the inveer while there are severe weather conditions including storm, lighting, etc.
· Before opening the housing, the SAJ inveer must be disconnected from the grid and PV generator; you must wait
for at least ve minutes to let the energy storage capacitors completely discharged after disconnecting from power
source.
WARNING
· The installation, seice, recycling and disposal of the inveers must be peormed by qualied personnel only in
compliance with national and local standards and regulations.
· Any unauthorized actions including modication of product functionality of any form may cause lethal hazard to the
operator, third paies, the units or their propey. SAJ is not responsible for the loss and these warranty claims.
· The SAJ inveer must only be operated with PV generator. Do not connect any other source of energy to the SAJ
inveer.
· Be sure that the PV generator and inveer are well grounded in order to protect propeies and persons.
CAUTION
sholy after operation.
· Risk of damage due to improper modications.
NOTICE
· Public utility only.
· The inveer is designed to feed AC power directly to the public utility power grid; do not connect AC output of the
inveer to any private AC equipment.
03 04
5min
Dangerous electrical voltage
· There is possibility of dying due to electrical shock and high voltage.
·The inveer will become hot during operation. Please do not touch the heat sink or peripheral suace during or

SAJ H2 Series Specifications

General

Brand	SAJ
Model	H2 Series
Category	Inverter
Language	English