System Option Programming
Refer to the “System Option Table” to review the system options. Read each option carefully to determine if
you wish to make any changes.
NOTE: You do not need to program this section unless you wish to change the default status.
Programming a System Option:
1. Turn the control lock to the PGM position.
2. Enter 3 0, press the SBTL key.
3. Enter a system option address
4. Press the QTY/TIME key.
5. Enter the number representing the status you have selected.
If there is more than one decision to be made in an address add the
values representing your choices for each decision and enter the sum.
6. Press the SUBTOTAL key.
7. Repeat from step 3 for each system option that you wish to change.
8. Press the CASH key to Finish system option programming.
System Option Flowchart
To Next Page
Loading...
