Sam4s ER-925 - Program Scans

59
Program Scans
Since much time and energy has been invested in the planning and programming of your ER-900 , it is
advisable to print a hard copy of the final program for future reference.
OTHER PROGRAM SCANS
1. Turn the control lock to the PGM position.
2. To print a program scan, enter 1 5, then press the SBTL key.
5
SBTL
1
3. In this step, there are three different ways to scan program information.
One is PLU, the other is Macro, the third is Others.
PLU PROGRAM SCAN
To read a single PLU code program information, enter the number of the PLU
and press PLU No. key, then repeat the same PLU No.
PLU
Enter the PLU#,
up to 15 digits
Enter the PLU#,
up to 15 digits
PLU
or
Press a PLU key on the keyboard and press the same key again.
PLU 1
PLU 1
To read multiple PLU program information, then enter the first number and
press the PLU No. key. Then enter the last number and press PLU No. key.
PLU
Enter the first
PLU#, up to 15
digits
Enter the last
PLU#, up to 15
digits
PLU
or
Press the first PLU key on the keyboard, followed by the last PLU key
PLU 1
PLU 10
MACRO PROGRAM SCAN
To read MACRO information, press the MACRO key to be scanned,
MACRO#
MACRO#
Refer to the chart below and enter a digit to represent the segment of the
program you wish to print, then press the QTY/TIME key. Repeat this
operation as required.