EasyManuals Logo

Sam4s Gcube-102 User Manual

Sam4s Gcube-102
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
OPERATOR’S Manual
9
CHAPTER 1
WARNING : Make sure that you use the power supply provided with the printer or
equivalent.
CAUTION : When connecting or disconnecting the power supply from the printer,
make sure that the power supply is not plugged into an electrical outlet.
Otherwise you may damage the power supply or the printer.
If the power supply’s rated voltage and your outlet’s voltage do not match, contact
your dealer for assistance. Do not plug in the power cord. Otherwise, you may
damage the power supply or the printer.
1. Make sure the printer is turned off.
2. Plug the DC cord connector into the power jack on the printer. If it is
necessary to connect the interface and the drawer, plug that connector
into the port on the printer. And clean up the cables.
↑ UP
NOTES : To remove the DC cable connector, make sure the power supply’s power cord
is unplugged and then grasp the connector at the arrow and pull it straight out.
1.5. Connecting the Power Supply

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sam4s Gcube-102 and is the answer not in the manual?

Sam4s Gcube-102 Specifications

General IconGeneral
BrandSam4s
ModelGcube-102
CategoryPrinter
LanguageEnglish

Related product manuals