Getting Started SER-7000 Program Manual
ENTER
When programming or selecting from window look-ups, press ENTER to
enter data into a field with the cursor remaining in the field.
ERR.CORR
Press ERR CORR immediately after an item to void that item.
FD STMP SHIFT
Press FD STMP SHIFT to shift the pre-programmed food stamp status of
an item prior to its registration.
FD STMP SUBTTL
Press FD STMP SUBTTL to display the total of food stamp eligible items
registered in the current transaction.
FD STMP TEND
Press the FD STMP TEND key to tender Food Stamps after the display of
the food stamp eligible subtotal. Depending upon function key
programming, change less than $1 may be applied to any cash balance or
issued as cash change.
GUEST #
Use to record the number of guests served by a transaction. The entry may
be compulsory. The entry appears on receipts and the kitchen printer/KVS.
HOLD
Use to identify an individual item, or an entire transaction so that the
designated items will not print/display at the kitchen printer/KVS at the
current finalization. Items designated as "hold" items will display on the
screen with an "H".
INACTIVE
The INACTIVE function key can be re-used as many times as necessary to
inactivate key locations.
KP ROUTING
The KP ROUTING key is used to override KP Time Period control. For
example, a restaurant might normally operate two kitchens at one time and
one kitchen at other times. In case the volume of business changes, the
manager might want to control the KP routing manually. Also, a single
item, or large order might be required to be sent to a different printer than
normal. Select STAYDOWN, TICKET POP UP or ITEM POP up
operation. To operate, press the key at any time inside or outside of a
transaction.
KEYBOARD LEVEL 1-5
Use to select one of the five keyboard levels.
LIST CHECK 1-4
Press LIST CHECK (for the appropriate tracking file) to display a list of all
open soft checks in the file.
MACRO OFF, P, R, X, Z,
VOID
Press the MACRO OFF, P, R, X, Z, or VOID key while programming a
macro sequence to allow the macro to set the register in the indicated control
lock position (without actually turning the control lock.)
MACRO PAUSE
Press the MACRO PAUSE key during macro programming to indicate a
pause in the macro. A macro will stop when it reaches the pause, and then
accept an operator key entry before continuing the macro sequence.
MACRO SET
Press the MACRO SET key to create a macro at any time without going
through the P-mode macro program.
MACRO 1 - 40
Use to execute one of forty possible preprogrammed key sequences.
MACRO #
Use to execute one of the forty possible macros by entering the macro
number and pressing the MACRO # key.
MDSE RETURN
Press the MDSE RETURN key to adjust items inside or outside of a
transaction.
To Next Page
Loading...
