Appendices SER-7000 Program Manual
Requisition Printers
Requisitions can be directed from any register to any printer in the system. For example, at
a food service counter with 3 registers and three preparation areas, registers and printers
might be connected in a system as in the diagram below:
Within this system, printing instructions from any of the registers can be directed to the
appropriate printer, for example:
x All registers direct receipts to printer #1.
x All registers direct drink items to printer #2
x All registers direct hot food items to printer #3
x All registers direct cold food items to printer #4
Notes for the Programmer:
x Use P-Mode program #1 “PLU”, to assign a PLU to a PLU Status Group.
x Use P-Mode program #2 “PLU Status Group” options #30 to enable printing on
kitchen printer and option #31 to assign status groups to KP#’s.
x Use P-Mode program #12 “Printer Tables & KV Routing”, selection #3 “Kitchen
Printer Routing” assign KP#’s to printers.
x Use P-Mode program #12 “Printer Tables & KV Routing”, selection #1 “System
Printer Configuration” assign printers to specific ports on registers within the
system.
SER-7000
#1
SER-7000
#2
SER-7000
#3
HUB
1 2 3 4
#1
Receipt
Printer
E-net
E-net
E-net
Serial 1
Serial 1 Serial 1
Serial 2
#2
Drink Requisition
Printer
#3
Hot Food
Requisition
Printer
#4
Cold Food
Requisition
Printer
To Next Page
Loading...
