Sam4s SPS-500 - Soft Check Posting

- 94 - SPS-500
SOFT CHECK POSTING
It is not necessary to print the check at each posting. The PRINT CHECK key will print the order at the designated
printer. The PRINT CHECK key can be programmed to automatically service the transaction.
Beginning a Check
Depending upon how
programmed:
Enter check number, press one of
the Recall Check functions, i.e.
RECALL #1, or
Press RECALL #1 to
automatically assign a check
number, or
Enter the table # and press the
appropriate Table # function, i.e.
TABLE 1. (Note: If the recall
function is set as “assigned by
register”, then a check number
will be assigned automatically
when the table is input.)
EMPLOYEE 1 .
C1 /T 6/G 2
P/BAL 0.00
TTL 0.00
PO1 ROn REG01
Optional:
Enter table number, press TABLE
1.
EMPLOYEE 1 .
C1 /T 6/G 2
P/BAL 0.00
TTL 0.00
PO1 ROn REG01