12
B.1 Manual bilge pumps:
The manual pump is installed in the rear cockpit bench seat
The brake is stored under the rear bench seat cover
Place the brake in the pump and start pumping
See drawing DDF PBL 061 009 Bilging system for the detailed layout
B - BILGING SYSTEM
The bilge pump system is not
designed to control a breach
Keep hull valves, cockpit drains, drain
holes and other opening/closing
devices in the closed or open position,
as appropriate, to minimise the risk of
ingress of water.
Manual bilge pump
strainer
IV- SAFETY
NOTE - Check the operation of each bilge pump at regular intervals. Clean debris from pump suction points or strainers. If valves are fitted in
the watertight bulkheads isolating the forward peaks, these should normally be kept closed and opened only to drain water into the main
bilges.
Warning
NOTICE
To Next Page
Loading...