80
XII - MAINTENANCE
Maintenance (cranage, careening, wintering, etc.)
•Do not park under the craft.
•Place the craft on chocks at the forward and aft bulkheads of each hull.
See DRAWING DDF ACC 061 002 DRY DOCK & LIFTING PLAN
There are many stainless steel parts on your craft, so regular maintenance is necessary.
The various surfaces (composite, PMMA, glass, stainless steel, teak) must be cleaned using appropriate products.
CRANAGE
Use suitable lifting equipment for the size of your catamaran.
It must be handled according to the drawing above, using a crane
or a travel-lift
The craft must be placed on cradles.
When launching it, remember to:
• Drain off the cable glands
• Check that the sea water pumps are correctly re-primed.
CAREENING
Always careen your boat in a place suitable for this purpose.
Wet surface: approximately 140 m².
WINTERING
Bring all cushions inside, remove the bimini covers, protect outdoor tables, drain the fresh water systems.
Do not park underneath the
craft.
Place the craft on chocks at the
forward and aft bulkheads of
each hull.
To Next Page
Loading...