Samick DCP-8 - Program Change,Bank LSB and Bank MSB

Program Change, Bank LSB, and Bank MSB
The following section demonstrates how to send MIDI Program Changes, Bank
LSB (Leas t Significant Byte) and Bank MSB (Most Significant Byte) values from
the piano to an external MIDI device or virtual instrument software program.
1.To send a single specific Program Number (Data Control knob assignment
remains unchanged):
Press the [Voice/Function] button to enter Function Mode.
Voice / -
Function
Press the Program Key (F#5).
Cancel Panic Data Contr Assign Bank MSB Bank LSB Program
Default
9 8 7 6 5 4 3 2 1 0
Enter
F#5
39
Now you are back in Performance Mode, and you can use the Data Control knob
to send values for the Continuous Controller (CC) you specified in Step 3.
Data Control
[Assignable]
NOTE
To reassign the Data Control knob for Voice Selection, press the Voice / Function
button and then press the Eb2 key. (This procedure is illustrated at the beginning of
the Function Mode section.)
Sending MIDI Program Changes
There are two ways to send MIDI Program Number changes. You can either enter
a single specific Program Number (Data Control knob assignment remains unchanged),
or you can assign the Data Control knob to send MIDI Program Changes.