4-4 EB 3018 EN
Shipment and on-site transport
4.4 Storing the regulator
Risk of regulator damage due to improper
storage.
Î Observe the storage instructions.
Î Avoid long storage times.
Î Contact SAMSON in case of different
storage conditions or longer storage
times.
We recommend to regularly check the regu-
lator and the prevailing storage conditions
during long storage periods.
Storage instructions
Î Protect the regulator against external in-
uences (e.g. impact).
Î Secure the regulator in the stored posi-
tion against slipping or tipping over.
Î Do not damage the corrosion protection
(paint, surface coatings). Repair any
damage immediately.
Î Protect the regulator against moisture
and dirt. Store it at a relative humidity of
less than 75%. In damp spaces, prevent
condensation. If necessary, use a drying
agent or heating.
Î Make sure that the ambient air is free of
acids or other corrosive media.
Î The permissible storage temperature of
standard regulators is –20 to +65°C.
NOTICE
!
Note
Î Do not place any objects on the regula-
tor.
Special storage instructions for elastomers
Elastomer, e.g. operating diaphragm
Î To keep elastomers in shape and to pre-
vent cracking, do not bend them or hang
them up.
Î Store elastomers away from lubricants,
chemicals, solutions and fuels.
− We recommend a storage temperature of
15°C for elastomers.
SAMSON's After-sales Service can provide
more detailed storage instructions on re-
quest.
Tip
To Next Page
Loading...
