Samson 3374 - Start-up; Start-up and Putting the Device Back into Operation

EB 3018 EN 6-1
Start-up
6 Start-up
The work described in this section is to be
performed only by personnel appropriately
qualied to carry out such tasks.
Risk of fatal injury due to electric shock.
Î Upon installation of the electric cables,
you are required to observe the regula-
tions concerning low-voltage installations
according to DINVDE0100 as well as
the regulations of your local power sup-
plier.
Î Use a suitable voltage supply which
guarantees that no dangerous voltages
reach the device in normal operation or
in the event of a fault in the system or
any other system parts.
Î Only perform the electrical connection
after switching off the supply voltage.
Make sure the supply voltage cannot be
switched on again unintentionally.
Risk of personal injury due to process me-
dium escaping.
Î Do not start up the regulator until all
parts have been mounted.
Risk of personal injury due to pressurized
components and process medium being dis-
charged.
Î Do not loosen the control line while the
valve is pressurized.
DANGER
!
DANGER
!
WARNING
!
Risk of burn injuries due to hot or cold
components and pipeline.
Regulator components and the pipeline may
become very hot or cold. Risk of burn inju-
ries.
Î Allow components and pipelines to cool
down or warm up to the ambient tem-
perature.
Î Wear protective clothing and safety
gloves.
Crush hazard arising from moving parts.
The regulator contains moving parts (actua-
tor and plug stem), which can injure hands
or ngers if inserted into the valve.
Î Do not insert hands or nger into the
yoke while the valve is in operation.
Î Disconnect the supply voltage and pro-
tect it against unintentional reconnection
before performing any work on the con-
trol valve.
Î Do not impede the movement of the actu-
ator or plug stem by inserting objects in-
to their path.
Î Before unblocking the actuator and plug
stem after they have become blocked
(e.g. due to seizing up after remaining in
the same position for a long time), re-
lease any stored energy in the actuator
(e.g. spring compression). See associat-
ed actuator documentation.
Î Before starting any work on the regula-
tor, depressurize plant sections as well as
the regulator.
WARNING
!
WARNING
!
WARNING
!