Samson 3374 - Page 64

9-2 EB 3018 EN
Servicing
Î Wear protective clothing, safety gloves
and eye protection.
Risk of personal injury due to the regulator
tipping.
Î Observe the regulator's center of gravity.
Î Secure the regulator against tipping over
or turning.
Risk of lifting equipment tipping over and
risk of damage to lifting accessories due to
exceeding the rated lifting capacity.
Î Only use approved lifting equipment and
accessories whose minimum lifting ca-
pacity is higher than the weight of the
valve (including actuator and packaging,
if applicable).
Î Refer to the 'Design and principle of op-
eration' section for the weights.
Risk of burn injuries due to hot or cold
components and pipeline.
Regulator components and the pipeline may
become very hot or cold. Risk of burn inju-
ries.
Î Allow components and pipelines to cool
down or warm up to the ambient tem-
perature.
Î Wear protective clothing and safety
gloves.
WARNING
!
WARNING
!
WARNING
!
Risk of regulator damage due to exces-
sively high or low tightening torques.
Observe the specied torques when tighten-
ing regulator components. Excessive tighten-
ing torques lead to parts wearing out more
quickly. Parts that are too loose may cause
leakage.
Î Observe the specied tightening torques
(see 'Tightening torques' in Annex).
Risk of regulator damage due to the use of
unsuitable tools.
Î Only use tools approved by SAMSON
(see 'Tools' in Annex).
Risk of regulator damage due to the use of
unsuitable lubricants.
Î Only use lubricants approved by
SAMSON (see 'Lubricants' in Annex).
NOTICE
!
NOTICE
!
NOTICE
!