Samson 3374 - Page 88

14-8 EB 3018 EN
Certicates
Revision no. 00
Classification: Public · SAMSON AKTIENGESELLSCHAFT · Weismüllerstraße 3 · 60314 Frankfurt, Germany Page 1 of 1
Declaration of Incorporation in Compliance with Machinery Directive 2006/42/EC
For the following product:
Type 2423 Valve
We certify that the Type 2423 Valve is partly completed machinery as defined in the Machinery Directive
2006/42/EC and that the safety requirements stipulated in Annex I, 1.1.2, 1.1.3, 1.1.5, 1.3.2, 1.3.4 and 1.3.7 are
observed. The relevant technical documentation described in Annex VII, part B has been compiled.
Products we supply must not be put into service until the final machinery into which it is to be incorporated has
been declared in conformity with the provisions of the Machinery Directive 2006/42/EC.
Operators are obliged to install the products observing the accepted industry codes and practices (good
engineering practice) as well as the mounting and operating instructions. Operators must take appropriate
precautions to prevent hazards that could be caused by the process medium and operating pressure in the valve
as well as by the signal pressure and moving parts.
The permissible limits of application and mounting instructions for the products are specified in the associated
mounting and operating instructions; the documents are available in electronic form on the Internet at
www.samsongroup.com.
For product descriptions refer to:
- Type 42-34 and Type 42-38 Differential Pressure Regulators with Flow Limitation:
Mounting and Operating Instructions EB 3013
- Type 42-36 Flow Regulator: Mounting and Operating Instructions EB 3015
- Type 42-36 E Pressure-independent Control Valve (PICV):
Mounting and Operating Instructions EB 3018
- Type 42-37 Flow and Differential Pressure Regulator as well as Type 42-39 Flow and Differential
Pressure or Pressure Regulator: Mounting and Operating Instructions EB 3017
Referenced technical standards and/or specifications:
- VCI, VDMA, VGB: "Leitfaden Maschinenrichtlinie (2006/42/EG) – Bedeutung für Armaturen, Mai 2018"
[German only]
- VCI, VDMA, VGB: "Zusatzdokument zum Leitfaden Maschinenrichtlinie (2006/42/EG) – Bedeutung für
Armaturen vom Mai 2018" [German only], based on DIN EN ISO 12100:2011-03
Comments:
- See mounting and operating instructions for residual hazards.
- Also observe the referenced documents listed in the mounting and operating instructions.
Persons authorized to compile the technical file:
SAMSON AG, Weismüllerstraße 3, 60314 Frankfurt am Main, Germany
Frankfurt am Main, 10 November 2021
Stephan Giesen
Director
Product Management
Peter Scheermesser
Director
Product Life Cycle Management and ETO
Development for Valves and Actuators
3