Samson 3510 Series - Page 49

EB 8091 EN 9-9
Servicing
23
25
26
22
28
24.2
27
24.1
5
24.2
4
Fig.9-2: Type3510 with insulating section
Legend for Fig.9-2
4 Intermediate piece
5 Seal
22 Plug stem extension
23 Fillister head screw
24.1 Bottom anti-rotation xture
24.2 Top anti-rotation xture (two-piece)
25 Washer
26 Hex nut
27 Washer
28 Insulating section
c) Version with bellows seal
See Fig.9-1 and Fig.9-3
1. Loosen the slotted nut (11) at the valve.
Remove the yoke (13) from the interme-
diate piece (4).
2. Loosen the llister head screw (23) and
hex nut (26).
3. Remove the top section of the top anti-ro-
tation xture (24.2) from the intermedi-
ate piece (4).
4. Unscrew the intermediate piece (4) out of
the bellows seal (7) and carefully lift it off
the plug stem (3.1).
5. Remove the washer (27) from the bellows
seal (7).
6. Remove the bottom section of the top an-
ti-rotation xture (24.2) from the bellows
seal (7).
7. Remove the seal (3.4). Carefully clean
the sealing faces in the intermediate
piece (4) and bellows seal (7).