Samson 3730-1 - Page 74

74 EB 8384-1 EN
Operating the positioner
Table14: Parameter codes
Codes marked by an asterisk (*) indicate that the positioner needs to be re-initialized afterwards
[...]Defaultsettings
P0 Status reading P11 Setpointcutoffincrease[OFF]
P1
Reading direction P12
Limit value A1 switching threshold
[2%]
P2*
Fail-safeposition[ATO]/ATO P13
Limit value A2 switching threshold
[98%]
P3* Pinposition[35] P14 Reading of set point w
P4* Nominalrange[MAX] P15 Start initialization
P5
Characteristic[0] P16
Start zero calibration
P6 Setpoint[4to20mA] P17 Start manual mode
P7 w/xdirectionofaction[>>] P18 Load default settings
P8* GainK
P
[50] P19 free
P9 Pressurelimit2.4bar[OFF] P20 Firmware version
P10 Setpointcutoffdecrease[ON] P21 Controlmode[PD]/PID