Samson 3730-4 - Page 27

Fault/diagnostic alarm
Default setting acc. to Pro
-
file 3.01 Condensed Status
Classified
Diagnosis
Yes No
Perhaps bias reduced (TEST)
0x80 GOOD_NON_SPECIFIC • –
Perhaps bias increased (TEST)
0x80 GOOD_NON_SPECIFIC • –
Working at full capacity
0x80 GOOD_NON_SPECIFIC • –
Working at full capacity (TEST)
0x80 GOOD_NON_SPECIFIC • –
Shifting working range
Shifting working range close position
0x80 GOOD_NON_SPECIFIC • –
Shifting working range max. open
0x80 GOOD_NON_SPECIFIC • –
Friction
Much higher over whole range
0x80 GOOD_NON_SPECIFIC • –
Much lower over whole range
0x80 GOOD_NON_SPECIFIC • –
Much higher over partial range
0x80 GOOD_NON_SPECIFIC • –
Much lower over partial range
0x80 GOOD_NON_SPECIFIC • –
Much higher over whole range (TEST)
0x80 GOOD_NON_SPECIFIC • –
Much lower over whole range (TEST)
0x80 GOOD_NON_SPECIFIC • –
Much higher over partial range (TEST)
0x80 GOOD_NON_SPECIFIC • –
Much lower over partial range (TEST)
0x80 GOOD_NON_SPECIFIC • –
Leakage pneumatics
Perhaps existing (TEST)
0x80 GOOD_NON_SPECIFIC • –
Perhaps existing
0x80
GOOD_NON_SPECIFIC
•
–
Perhaps too large (TEST)
0x80
GOOD_NON_SPECIFIC
•
–
Perhaps too large
0x80
GOOD_NON_SPECIFIC
•
–
Limit range
Down
0x80
GOOD_NON_SPECIFIC
•
–
Up
0x80
GOOD_NON_SPECIFIC
•
–
Modification impossible
0x80 GOOD_NON_SPECIFIC
•
–
Dynamic stress factor
Load factor > 90 %
0x80
GOOD_NON_SPECIFIC
•
–
Inner leakage (shut-off)
Perhaps existing
0x80
GOOD_NON_SPECIFIC
•
–
KH 8384-4 EN 27
Status alarms according to Profile 3.01 Condensed Status