Troubleshooting
Samsung Electronics 4-7
- PCB option code input method(example : 066064-170373)
■ AVXWVH66E6, AVXWBH666E6, AVXTJH666E6
ND666VH666, ND666BH666, ND666JH666
Step 1 : Enter the Option Setup mode.
1
st
Take out the batteries of remote control.
2
nd
Press the temperature button simultaneously and
insert the battery again.
3
rd
Make sure the remocon display shown as .
Step 2 : Enter the Option Setup mode and select your option according to the following procedure.
1
2
5
3 2
1 4
6
✳ Setting is not required if you must
a value which has a
default.
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
3
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
4
5
6
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
The default value is .
Otherwise, push the button to
.
Every time you push the button, the display panel reads
or repeatedly.
$9;&6+B$BaLQGG
To Next Page
Loading...
